Filter
Top Products
38 © 2007 VBrick Systems, Inc.
Conferencing
Setup
This option enables/disables the ability of a user to initiate a
conference using an IR remote control unit. Disabled prevents this
VBrick from appearing on the Conference Guide of other VBricks.
Conferencing
Accept
If Manual, the called party on this VBrick must explicitly accept the
call with the IR remote control. If automatic, the call will be accepted
without any action on the part of the called party.
Local Ringer Used to enable/disable the ringer.
Conference End
Display Mode
Allows the choice of what is displayed when the conference ends.
Display either Picture-in-Picture (with the local encoder view) or a
Blank Screen.
Local Ringer IR If Enabled, the ringer may be enabled or disabled via the IR remote by
the user (operator) of this VBrick. If disabled, the local operator
cannot change the state of the ringer. It will remain as set above in
"local ringer".
Conferencing
Name
Used to configure the name of the user (operator) of this VBrick. This
is the name, which will appear on the conference guide screen used to
set up the conference. The default entry is \h or \H, which identifies
the unit by the Host Name of VBrick appliance.
SAP IP Address The SAPs for Conference Call setup are sent to this destination IP
Address.
SAP Port The SAPs for Conference Call setup are sent to this destination IP/
UDP port.
SAP Retransmit
Time
Allows setting the SAP retransmit time.