Filter
Top Products
Chapter 3: Perform Basic Operations
42 ViewCast
Starting an Encoder Group
To start an encoder group, click the Start link to the right in the Start column of the group you want
to start. The encoder group will start in a few seconds. The system displays any errors on the
Starting window while the group starts.
NOTE: With each encoder started, more system resources (CPU cycles) are consumed.
ViewCast recommends the total CPU threshold not exceed an average of 50 %.
Stopping an Encoder Group
To stop an encoder group, click the Stop link to the right in the Stop column of the group you want
to stop. The encoder group will stop in a few seconds. The system displays any errors on the
Stopping window while the group stops.