Filter
Top Products
–
63
–
7. The system will search for the next zone that does not have a serial
number associated with it. If one is found, the prompt in step 5, along
with the appropriate zone number, will be displayed. Follow steps 5
and 6 for the remaining wireless zones.
Enter Zn Num.
(00 = Quit) 15
8. After all wireless zones have been displayed, whether enrolled or not,
the "Enter Zn Num." prompt will appear.
Enter "00" to exit the serial number Sequential mode and return to the
data field programming mode.
When you have finished programming all zones, test each using the
system's TEST mode (see
TESTING THE SYSTEM
section).
Do not use the Transmitter ID Sniffer mode for testing, as it will only
check for transmission of one zone on a particular transmitter, and
NOT the zones assigned to each additional loop.