VistaQuest VQ 5020 Digital Camera User Manual


 
-
10
-
7. Taking Pictures
• Taking a Picture
1. Turn on the camera.
2. The TFT will display image and symbols.
3. Slide the
Function
switch to
(Capture Status).
4. The TFT will display (Snapshot Mode). If icon is
different, Press the joystick down until the icon appears on the TFT.
5. Point the camera at the subject, use the TFT to compose the image. (If turn
the switch to
Macro
, you can take picture as close as 19.5cm; If turn
the switch to
Portrait
, you can take picture as close as 0.95m to 1.95m.)
6. Holding the camera still, gently press the Shutter button to take the picture.
Note: How to take a good shot? After pressing down shutter button, keep your
hand steady for 2 seconds to get best result.
• Taking Continuous Pictures
1. Make sure the Function switch is set to (Capture Status)
2. Press the joystick down until appears on the TFT. (Continuous Mode)
3. Point the camera at the subject, use the TFT to compose the image.
4. Holding the camera still, gently press the shutter button to take the pictures
Note: Flash is deactivated at this mode. You will see the icon on the TFT.