Filter
Top Products
VIVOTEK
52 - User's Manual
Security > IEEE 802.1X
Advanced Mode
Enable this function if your network environment uses IEEE 802�1x, which is a port-based network
access control� The network devices, intermediary switch/access point/hub, and RADIUS server
must support and enable 802�1x settings�
The 802�1x standard is designed to enhance the security of local area networks, which provides
authentication to network devices (clients) attached to a network port (wired or wireless)� If all
certicates between client and server are veried, a point-to-point connection will be enabled; if
authentication fails, access on that port will be prohibited� 802�1x utilizes an existing protocol, the
Extensible Authentication Protocol (EAP), to facilitate communication�
■
The components of a protected network with 802.1x authentication:
1�
Supplicant: A client end user (camera), which requests authentication�
2�
Authenticator (an access point or a switch): A “go between” which restricts unauthorized end
users from communicating with the authentication server�
3�
Authentication server (usually a RADIUS server): Checks the client certificate and decides
whether to accept the end user’s access request�
■
VIVOTEK Network Cameras support two types of EAP methods to perform authentication: EAP-
PEAP and EAP-TLS�
Please follow the steps below to enable 802.1x settings:
1� Before connecting the Network Camera to the protected network with 802�1x, please apply
a digital certificate from a Certificate Authority (i�e�, your network administrator) which can be
validated by a RADIUS server�
2� Connect the Network Camera to a PC or notebook outside of the protected LAN� Open the
conguration page of the Network Camera as shown below. Select EAP-PEAP or EAP-TLS as
the EAP method� In the following blanks, enter your ID and password issued by the CA, then
upload related certicate(s).
Supplicant
(Network Camera)
Authenticator
(Network Switch)
Authentication Server
(RADIUS Server)