Wow Wee 8033 Digital Camera User Manual


 
14
To charge the batteries:
1. Ensure that the power to the electrical outlet is turned on and that Rovio is
turned on by pressing the power button; Rovio’s LEDs will light up.
2. Place Rovio in its assembled charging dock as illustrated.
The LEDs on Rovio will pulse quickly to indicate that it has begun charging.
3. During charging, the LEDs on Rovio will pulse
slowly; a single charge takes approximately two
hours.
When Rovio has nished charging the LEDs will
remain lit. It is safe to leave Rovio on its charging
dock after the charge has completed.
Low battery
When Rovio’s batteries begin to run low, it will warn you with the following:
Rovio interface warning message.
Power switch LED light indicator ashes green, orange or red (refer to the
section Power switch LED light indicator).
If Rovio is in the same room as its charging dock and the interface indicates that it
has a navigation signal, it will automatically try to return to the charging dock when
its batteries are running low after you click on the low battery warning message.
Otherwise, you can send it back to its charging dock by clicking on the Home
button on the interface. Refer to the Auxiliary controls table in the Description of
interface section for details.
If you ignore the request to drive Rovio back to its charging dock and continue to use
it, Rovio will shut off automatically when its batteries are drained, and you might not
be able to drive it back to the charging dock to recharge.
NOTE: Rovio must detect the charging base before it can navigate home.
Getting started
Installing and charging the battery pack