fault-finder
OVERVIEW
Category:
configPrimary context:
interface (page 204)Related Commands
the section called “fault-finder” (page 551)
Usage: [no] fault-nder <all|bad-driver|bad-transceiver|bad-cable|
too-long-cable|over-bandwidth|broadcast-storm|
loss-of-link>
[sensitivity <low|medium|high>]
Description: Enable/disable fault nder and set sensitivity.
Default is 'sensitivity medium'.
COMMAND STRUCTURE
■ [no] fault-finder fault-finder < all | bad-driver | bad-transceiver | ... > -- Enable/disable fault finder
and set sensitivity (p. 178)
■ fault-finder sensitivity < low | medium | high > -- Define fault finder sensitivity to events. (p. 178)
COMMAND DETAILS
sensitivity (p. 178)fault-finder (p. 178)
fault-finder
■ [no] fault-finder < all | bad-driver | bad-transceiver | ... >
Usage: [no] fault-nder <all|bad-driver|bad-transceiver|bad-cable|
too-long-cable|over-bandwidth|broadcast-storm|
loss-of-link>
[sensitivity <low|medium|high>]
Description: Enable/disable fault nder and set sensitivity.
Default is 'sensitivity medium'.
Supported Values:
■ all -- All fault types.
■ bad-driver -- Too many undersized/giant packets.
■ bad-transceiver -- Excessive jabbering.
■ bad-cable -- Excessive CRC/alignment errors.
■ too-long-cable -- Excessive late collisions.
■ over-bandwidth -- High collision or drop rate.
■ broadcast-storm -- Excessive broadcasts.
■ loss-of-link -- Link lost detected.
■ duplex-mismatch-HDx -- Duplex Mismatch. Reconfig port to Full Duplex.
■ duplex-mismatch-FDx -- Duplex Mismatch. Reconfig port to Auto.
sensitivity
■ fault-finder sensitivity < low | medium | high >
Dene fault nder sensitivity to events.
178© 2009 Hewlett-Packard Development Company, L.P.
