Specify the MED TLV List to be advertised.
Supported Values:
■ capabilities -- Capability TLV
■ network_policy -- Network Policy TLV
■ location_id -- Location Id TLV
■ poe -- Poe TLV
omodes
■ lldp admin-status [ETHERNET] PORT-LIST < TxOnly | RxOnly | Tx_Rx | ... >
Set the operational mode: transmit | receive |
transmit-receive | disable.
Supported Values:
■ TxOnly -- Set in transmit mode.
■ RxOnly -- Set in receive mode.
■ Tx_Rx -- Set in transmit & Receive mode.
■ disable -- disable.
radio-ports
■ [no] lldp auto-provision radio-ports
Usage:[no] lldp auto-provision radio-ports [suggested-auto-vlan|auto-vlan]
<vid>
Description: Congure various parameters related to automatic
provisioning for the radio-port application.
If no additional parameters following the radio-ports
parameter this command will enable the auto-provision
option (use the [no] keyword to disable the
auto-provision option).
Next Available Options:
■ auto-vlan -- Create a VLAN, with the specified VLAN id value, to be used as the radio-ports
controller auto-generated VLAN. (p. 354)
■ vlan-base < 2 to 4094 > -- Assign the default value of the VLAN id to be used if an auto-generated
VLAN is created for a radio-port application. (VLAN-ID) (p. 359)
refresh-interval
■ lldp refresh-interval < 5 to 32768 >
Usage: lldp refresh-interval <5-32768>
Description: Set refresh interval/transmit-interval in seconds.
The default is 30.
The refresh interval/transmit-interval should be greater
than or equal to (4*delay-interval).
The default value of delay-interval is 2.
Range: < 5 to 32768 >
run
■ [no] lldp run
358© 2009 Hewlett-Packard Development Company, L.P.
lldpCommand Line Interface Reference Guide
