VX-8R OPERATING MANUAL 159
SET MODE ITEM 99: TONE FREQUENCY
Function: Setting of the CTCSS Tone Frequency
Available Values: 50 standard CTCSS tones
Default: 100.0 Hz
SET MODE ITEM 100: TONE-SRCH MUTE
Function: Enables/Disables the receiver audio output while the Tone Search Scanner is
activated.
Available Values: ON / OFF
Default: ON
SET MODE ITEM 101: TONE-SRCH SPEED
Function: Selects the Tone Search Scanner speed.
Available Values: FAST (2.5 tone/sec) / SLOW (1.25 tone/sec)
Default: FAST (2.5 tone/sec)
SET MODE ITEM 102: TOT
Function: Setting of the TOT time
Available Values: OFF / 0.5min - 10.0min (0.5min/step)
Default: 3.0min (3 minutes)
The time-out timer shuts off the transmitter after a continuous transmission which is equal
to the programmed time.
SET MODE ITEM 103: UNIT OFFSET
Function: Cariblating the Sensor Unit.
Available Values: BARO:
–
1
000 ~ +1000, ALTITUDE:
–
1
000 ~ +1000
Default: BARO: 0, ALTITUDE: 0
SET MODE ITEM 104: UNIT SELECT
Function: Select the measurement units of the Sensor Unit.
Available Values: TEMP: °C / °F, BARO: hPa / mb / mmHg / inch, ALTITUDE: m / ft
Default: Depends on the transceiver version
SET MODE ITEM 105: VFO MODE
Function: Selects or disables the VFO band edge limiting for the current band.
Available Values: ALL / BAND
Default: BAND
ALL: When the VFO frequency reaches the high edge of the current band, the VFO
frequency will jump to the low band edge of the next band (or vice versa).
BAND: When the VFO frequency reaches the high band edge of the current band, the
VFO frequency will jump to the low band edge of the current band (or vice versa).
SET MODE
SET MODE SELECTION DETAILS
