VX-8R OPERATING MANUAL 73
Bluetooth
®
OPERATION
ACTIVATION
1. Press and hold the key for one second to enter the Set Mode.
2. Rotate the DIAL knob to select Set Mode Item
17:17:
17:17:
17:
BLUETOOTH SETBLUETOOTH SET
BLUETOOTH SETBLUETOOTH SET
BLUETOOTH SET.
3. Press the key briefly to enable selection of this Set Mode
Item.
4. Rotate the DIAL knob to select the TX/RX switching cir-
cuit of the Bluetooth
®
function:
VOX: OFFVOX: OFF
VOX: OFFVOX: OFF
VOX: OFF: Disable the TX/RX switching circuit of
the Bluetooth
®
function (RX only).
VOX: PTTVOX: PTT
VOX: PTTVOX: PTT
VOX: PTT: Activates the Bluetooth
®
function for use with the PTT circuit.
VOX: VOX HIGHVOX: VOX HIGH
VOX: VOX HIGHVOX: VOX HIGH
VOX: VOX HIGH: Activates the Bluetooth
®
function with the VOX feature (VOX
Gain: High).
VOX: VOX LOWVOX: VOX LOW
VOX: VOX LOWVOX: VOX LOW
VOX: VOX LOW: Activates the Bluetooth
®
function with the VOX feature (VOX
Gain: Low).
5. Press the key, then rotate the DIAL knob to select the
Battery Saver function:
SAVE: ONSAVE: ON
SAVE: ONSAVE: ON
SAVE: ON: Activates the Battery Saver in the BH-1
(
or
BH-2
)
.
If there has been no signal or key activity for 20 seconds, the Battery
Saver automatically puts the BH-1
(
or BH-2
)
to “sleep”, to conserve
battery life. When a signal is received or the PTT switch is pressed, the
BH-1
(
or BH-2
)
will wakeup and become active again.
Furthermore, if there has been no signal or key activity for 10 minutes,
the BH-1
(
or BH-2
)
will turn off automatically.
SAVE: OFFSAVE: OFF
SAVE: OFFSAVE: OFF
SAVE: OFF: Disable the Battery Saver in the BH-1
(
or BH-2
)
.
6. Press the key, then rotate the DIAL knob to select the
receiver audio output mode of the Bluetooth
®
unit (this
parameter is ignored when using the BH-2 Bluetooth
®
Headset):
MODE: STEREOMODE: STEREO
MODE: STEREOMODE: STEREO
MODE: STEREO: Outputs stereo receive audio while listening to the FM Broadcast
band.
Note: When this mode is selected, the VOX function does not work
even if the VOX function is selected in step 4. above. The TX/RX
switching is performed by pressing the PTT switch.
MODE: MONOMODE: MONO
MODE: MONOMODE: MONO
MODE: MONO: Outputs monaural receive audio while listening to the FM Broad-
cast band.
7. If you wish to turn the Bluetooth
®
unit off to conserve transceiver battery power
when you are not operating the Bluetooth
®
function, perform the following proce-
dures, otherwise, skip to next step.
