VX-8R OPERATING MANUAL62
VFO SCANNING
This mode allows you to scan on the VFO mode.
1. Select the VFO mode by pressing the key, if necessary.
2. Press and hold in the key, then rotate the DIAL knob while holding in the
key (the current bandwidth for the VFO scanner will appear
on the display) to select the bandwidth for the VFO scan-
ner. Available selections are
±1 MHz±1 MHz
±1 MHz±1 MHz
±1 MHz,
±2 MHz±2 MHz
±2 MHz±2 MHz
±2 MHz,
±5 MHz±5 MHz
±5 MHz±5 MHz
±5 MHz,
BANDBAND
BANDBAND
BAND,
ALLALL
ALLALL
ALL, and
PMS-XPMS-X
PMS-XPMS-X
PMS-X.
±1 MHz±1 MHz
±1 MHz±1 MHz
±1 MHz,
±2 MHz±2 MHz
±2 MHz±2 MHz
±2 MHz,
±5 MHz±5 MHz
±5 MHz±5 MHz
±5 MHz: The scanner will sweep frequencies within the selected
bandwidth.
BANDBAND
BANDBAND
BAND: The scanner will sweep frequencies only on the cur-
rent band.
ALLALL
ALLALL
ALL: The scanner will sweep all frequencies between 1.8
MHz and 999.99 MHz (except the FM Broadcast Band:
76 - 107 MHz).
PMS-XPMS-X
PMS-XPMS-X
PMS-X: The scanner will sweep frequencies within the cur-
rently-selected PMS frequency pair. See page 68 for
details.
3. Release the key to start scanning.
4. When the scanner encounters a signal strong enough to open the squelch, the scanner
will halt temporarily; the decimal point of the frequency display will blink during this
“Pause” condition.
5. The scanner will then resume according to the Scan-Resume mode selected in the
previous section.
6. To cancel scanning, press the PTT switch or key.
1) If you want to change direction of the scan while it is underway, rotate the
DIAL knob one click in the opposite direction. You’ll see the scanner turn
around and change frequency downward!
2) You may initiate upward or downward scanning in the previously selected band-
width, by pressing and holding either or key for one second, respectively.
3) You may change the scanner’s method of operation so the VFO frequency will jump
to the low band edge of the next band when the VFO frequency reaches the high edge
of the current band (or vice versa). See page 159 regarding Set Mode Item 105: VFO
MODE.
SCANNING
