VX-8R OPERATING MANUAL 43
CTCSS/DCS/EPCS OPERATION
PROGRAMMING THE USER MELODY
Three User Beep Memories are provided, allowing you to create unique original beep
tone melodies.
Each User Beep Memory can store up to 64 steps with three octaves (“
C1C1
C1C1
C1” through “
B3B3
B3B3
B3”).
1. Press and hold the key for one second to enter the Set Mode.
2. Rotate the DIAL knob to select Set Mode Item
12: BEEP12: BEEP
12: BEEP12: BEEP
12: BEEP
MELODYMELODY
MELODYMELODY
MELODY.
3. Press the key briefly to enable adjustment of this Set
Mode Item.
4. Rotate the DIAL knob to select the memory slot into which
you wish to store your programmed beep melody. Avail-
able selections are
11
11
1,
22
22
2, and
33
33
3. The previously stored beep
melody will be displayed.
5. Press the key to enable programming the beep melody.
Press and hold the key for one second to clear any
previous beep melody, if desired.
6. Rotate the DIAL knob to select the first beep tone of the
User Beep Melody. Available selections are
C1C1
C1C1
C1 -
B3B3
B3B3
B3.
7. Press the key, then rotate the DIAL knob to set the
length of the first beep tone. Available selections are
10ms10ms
10ms10ms
10ms
(10 msec) -
2500ms2500ms
2500ms2500ms
2500ms (2.5 sec).
8. Press the key to accept the first beep tone of the User
Beep Melody.
9. If you make a mistake, press the key to back-space the
cursor, then re-enter the correct beep tone or length.
10. Repeat steps 6 - 9 until you have completed the User Beep
Melody.
11. When there is a beep tone, which you wish to delete, bring
the cursor to that beep tone using the / key, then
press the key repeatedly until the “
SELECTSELECT
SELECTSELECT
SELECT” notation in
the “Operation Mode” slot turns into “
DELETEDELETE
DELETEDELETE
DELETE”. Now, press
and hold in the key for one second to delete that beep
tone.
CTCSS/DCS/EPCS BELL OPERATION
Step Operation Mode
Memory Slot Tone Length
Beep Tone
C2C1 C3D2D1 D3E2E1 E3F2F1 F3G2G1 G3A2A1 A3B2B1 B3
