Filter
Top Products
11
NNOOTTEE::
In addition to the supplied 15-foot multi-conductor cable, optional 6, 9, 30
and 50-foot lengths are available from your authorized Air Techniques Dealer
at an extra cost.
Camera Handpiece Connection - Carefully connect the supplied Camera Handpiece Cable
between the Camera Handpiece and Control Module as follows:
1. Using the gray molded connector cable end, align the connector key with the keyway of the
Handpiece connector.
2. Insert straight into Handpiece connector until it securely snaps into place.
3. Using the 10-pin quick disconnect plug end, align connector key with the keyway of the mating
CAMERA connector located on the front panel of the Control Module.
4. Insert the connector straight into the mating CAMERA connector until it securely snaps into
place.
A5050 Control Module/Camera Connection
Camera Handpiece Connection
C
ONNECTOR KEY
H
ANDPIECE CABLE
10-PIN QUICK
DISCONNECT PLUG
C
AMERA HANDPIECE
DO NOT TWIST OR TURN THE CABLE CONNECTORS. EACH CONNECTOR IS
KEYED AND MATES STRAIGHT ON WITH ASSOCIATED DEVICE CONNECTOR
.
Handpiece Holder Installation - Remove the protective film from the double-sided adhesive
on the Handpiece Holder and attach the Holder to a flat, clean dry surface where the Camera
Handpiece will be located.
USE CARE WHEN ADHERING THE HANDPIECE HOLDER TO SELECTED SURFACE.
THE DOUBLE-SIDED ADHESIVE FASTENS QUICKLY AND PERMANENTLY.
INSTALLATION