Filter
Top Products
12
REAR OF USER PC
6-FOOT (2M ) USB 2.0 HIGH
SPEED CABLE (SUPPLIED)
USB 2.0 HIGH
SPEED PORT
REAR OF ACCLAIM
CONTROL MODULE
NOTES:
On PC's that have both front and rear USB 2.0
high speed ports, it is recommended that the
camera be connected to one of the rear
mounted ports for best results.
Minimum PC processor and operating system
requirements are listed in the Preinstallation
Information of this manual.
A DirectX 9 user-supplied compliant streaming
video capture software application must be
installed on the PC to display live video. The
supplied CD provides the required WDM drivers.
USB Cable Connection Directly to PC
REAR OF USER PC
6-FOOT (2M ) USB 2.0 HIGH
SPEED CABLE (SUPPLIED)
USB 2.0
HIGH
SPEED
PORT
SELF-POWERED
USB 2.0 HIGH
SPEED HUB
POWER
SUPPLY
ADAPTER
UP TO 16-FOOT (5M) USB 2.0
HIGH SPEED CABLE
REAR OF ACCLAIM
CONTROL MODULE
NOTES:
A Hub may be used to connect the
camera to the PC when the connection
is longer than 6 feet or when the PC
only has a single USB 2.0 high speed
port and the camera must be connected
along with other USB devices.
DO NOT use a USB BUS POWERED
HUB. Use only a self powered USB 2.0
high speed hub (ie: is powered from it's
own AC line powered supply).
Follow instructions provided with the
hub to install it before connecting the
camera.
USB Cable Connection via Hub
Control Module USB Video Connection Options - Refer to corresponding figure below and
perform the following procedure to connect the USB 2.0 High Speed Video output of the Acclaim
Control Module to the associated PC computer as desired.
1. Connecting Directly to PC. Connect the supplied 6-foot USB 2.0 high-speed cable between
the USB connector located on the rear of the Control Module to be connected and directly to
the USB 2.0 high speed port on the computer.
2. Connecting via High Speed Hub. Connect the supplied USB 2.0 high-speed cable between
the USB connector located on the rear of the Control Module to be connected and the self-
powered USB 2.0 High Speed Hub. If necessary connect an additional USB 2.0 high-speed
cable up to 16 feet long between the High Speed Hub and the USB 2.0 high speed port on
the computer.
3. With USB connection accomplished, refer to page 13 and install the WDM drivers from the
supplied CD onto the PC to enable the Acclaim Camera system to communicate with the
user-supplied USB streaming video software application running on the PC.
INSTALLATION