Filter
Top Products
4
SAFETY NOTICE
GENERAL
This equipment has been designed to minimize exposure of personnel to hazards. While the
Acclaim Camera System is designed for safe operation, certain precautions must be observed.
Use of the Acclaim Camera System not
in conformance with the instructions specified in this
manual may result in permanent failure of the unit.
KNOWLEDGE OF WARNINGS AND CAUTIONS
Users must exercise every precaution to ensure personnel safety, and be familiar with the warnings
and cautions presented throughout this manual and summarized below.
CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK
, DO NOT REMOVE THE COVER OF THE
CONTROL MODULE
OR
POWER SUPPLY ADAPTER. THERE ARE NO USER-SERVICEABLE PARTS INSIDE. SERVICING SHOULD BE
PERFORMED BY QUALIFIED DEALER SERVICE REPRESENTATIVES ONLY
.
C
ONNECTING ANY DEVICE TO THE ACCLAIM CAMERA SYSTEM THAT DOES NOT MEET THE EQUIVALENT
SAFETY REQUIREMENTS OF THE SYSTEM MAY REDUCE THE SAFETY EFFECTIVENESS OF THE
ACCLAIM
CAMERA SYSTEM.
T
URN OFF POWER AND UNPLUG THE ACCLAIM CAMERA SYSTEM COMPONENTS BEFORE PERFORMING
CLEANING PROCEDURES
.
WARNING: TO PREVENT FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
D
O NOT SPRAY CLEANING LIQUIDS OR DISINFECTANTS DIRECTLY ON THE CAMERA HANDPIECE OR
CONTROL MODULE
. USE CARE NOT TO ALLOW LIQUIDS TO RUN INTO INTERNAL CIRCUITRY
.
D
O NOT WIPE THE SURFACES USING BENZINE, THINNER, ETC. AS THIS MAY DEGRADE THE FINISH.
DO NOT ATTEMPT INTERNAL SERVICE
The interior of each component of the Acclaim system is only accessible by removing
hardware with tools and should only be opened and serviced by an authorized Air Techniques’
Dealer Service Technician. Please contact your local authorized Air Techniques dealer for service.
Failure to heed this warning may result in equipment damage and voiding the warranty.
ATTENTION USERS:
MANUFACTURING DATE CODE ON SERIAL NUMBER LABEL IS IN THE FORMAT M
ONTH YYYY.
Alerts users to important Operating
and Maintenance instructions. Read
carefully to avoid any problems.
Warns users that uninsulated voltage
within the unit may be of sufficient
magnitude to cause electric shock.
Indicates type BF equipment in
accordance with IEC 60601-1