Filter
Top Products
IP Wireless Security Motorized Camera
A02-IPCAM2-W54_ME01 68
Question Answer
I cannot access the IP
Wireless Security
Motorized Camera from
a web browser.
Another possible reason is the IP Address is located on a
different subnet. To fix the problem, run the PING utility
(follow the instructions in Appendix B - PING Your IP
Address). If the utility returns “no response” or similar, the
finding is probably correct, then you should proceed as
follows:-
In Windows 95/98/2000 and Windows NT, double check the
IP Address of the IP Wireless Security Motorized Camera is
within the same subnet as your workstation.
Click “Start”, “Setting”, “Control Panel”, and the “Network”
icon.
Select TCP/IP from the “Network” dialog box and from the
“TCP/IP Properties” dialog box click “Specify an IP address”.
If the IP Wireless Security Motorized Camera is situated on a
different subnet than your workstation, you will not be able to
set the IP address from this workstation. To verify make sure
the first 3 sections of the IP address of the IP Wireless
Security Motorized Camera corresponds to the first 3 sections
of the workstation. Therefore the IP address of the IP
Wireless Security Motorized Camera must be set from a
workstation on the same subnet.
Question Answer
I cannot access the IP
Wireless Security
Motorized Camera from
a web browser.
Other possible problems might be due to the network cable.
Try replacing your network cable. Test the network interface
of the product by connecting a local computer to the unit,
utilizing a standard Crossover (hub to hub) Cable. If the
problem is not solved the IP Wireless Security Motorized
Camera might be faulty.
Question Answer
Why does the Power
LED not light up
constantly?
The power supply used might be at fault. Confirm that you
are using the provided power supply DC 5V for the IP
Wireless Security Motorized Camera and verify that the
power supply is well connected.