Filter
Top Products
IP Wireless Security Motorized Camera
A02-IPCAM2-W54_ME01 69
Question Answer
Why does the Link LED
not light up properly?
• There might be a problem with the network cable. To
confirm that the cables are working, PING the address
of a know device on the network. If the cabling is OK
and your network is reachable, you should receive a
reply similar to the following (…bytes = 32 time = 2
ms).
• The network device utilized by the IP Wireless
Security Motorized Camera is not functioning properly
such as hubs or switches. Confirm the power for the
devices are well connected and functioning.
• The wireless connection might be at fault. In ad-hoc
mode make sure the IP Wireless Security Motorized
Camera wireless channel and ESS-ID is set to match
the PC/Notebook wireless channel and ESS-ID for
direct communication. Under infrastructure mode
make sure the ESS-ID on the PC/Notebook and the IP
Wireless Security Motorized Camera must match with
the Access Point’s ESS-ID.
Question Answer
Why does the IP
Wireless Security
Motorized Camera work
locally but not
externally?
• Might be caused from the firewall protection. Need to
check the Internet firewall with your system
administrator.
• The default router setting might be a possible reason.
Need to double check if the configuration of the
default router settings is required.
Question Answer
Why does a series of
broad vertical white line
appears through out
the image?
A likely issue is that the CMOS sensor becomes overloaded
when the light source is too bright such as direct exposure to
sunlight or halogen light. You need to reposition the IP
Wireless Security Motorized Camera into a more shaded area
immediately as this will damage the CMOS sensor.