41
AXIS 225FD - Unit Connectors
Power connections
Power can be supplied to the camera by the following methods:
• PoE (Power over Ethernet) via the network cable. This will automatically be detected if
available via the network. Note that PoE provides power for the camera only (not the
heater).
• Connect the supplied indoor power adapter to the power connector block in the camera
casing. Note that this indoor power adapter provides power for the camera only (not
the heater).
• Connect an outdoor power supply to the power connector block in the camera casing.
For information on available outdoor power supplies, please visit the Support pages at
http://www.axis.com/techsup/
Power Connector Block
The power connector block supports both AC and DC input power.
The DC supply is 9-24V. Connect the negative pole to the GND pin and the positive pole to
the DC+ pin.
The AC supply is 10-24V. Connect the AC poles to the AC pins.
Power connector block pin assignment table.
Pin Function
GND Ground/DC-
AC/DC+ AC and DC+, power input for mains power to unit
AC AC power input for mains power to unit
AC
AC
DC+
GND