Filter
Top Products
Global View Station 1000 Test Software | en 25
Bosch Security Systems, Inc. Operations Manual F.01U.173.867 | 2.0 | 2010.11
Using the PTCR-20 Software
1. Run PTCR-20. The PC shows the display below.
Figure 6.2 PTCR-20 Main Screen
2. Verify COM port and Baud rate (9600 bps), and then click START. The COM port varies
from computer to computer.
Figure 6.3 Verify COM Port and Baud Rate
The Handshake icon below indicates a communication link between the Pan/Tilt motor
and the PC has been established.
Figure 6.4 PTCR-20 Main Screen with Handshake
3. After testing and setup, exit PTCR-20, disconnect the RS232 cable, and reconnect the
green terminal blocks in the PSU. Contact a Bosch service centre for further instructions
as needed.