Filter
Top Products
26 en | Test Software Global View Station 1000
F.01U.173.867 | 2.0 | 2010.11 Operations Manual Bosch Security Systems, Inc.
6.1.1 Default Parameters
1. Click the SETUP button. The default setup parameters are as shown below.
Figure 6.5 Default Setup Settings
2. Click the CAMERA button. The default parameters are as shown below.
Figure 6.6 Default Camera Settings
6.1.2 Using PTCR-20 to Set Soft Limits and Camera Control
In the software, click the Jog/Limits button. Use the SL (soft limit) Override button as
needed. Use the track pad to the left of the Set Soft Limit controls to move the camera to the
appropriate soft limit position. The Set Soft Limit buttons correspond to the direction applied
on the track pad.
For example, click the “U” direction on the track pad until the camera has reached the desired
soft limit position. Then, click the Set Up Soft Limit to set the Up Soft Limit. Repeat for the
Clockwise, Counter Clockwise, and Down Soft Limits.
NOTICE!
Disengage the SL Override before exiting the software.