Filter
Top Products
2-38
Motion Detection Setting Tool
(1)Setting Frame Rate
When this check box is selected, the camera's frame rate for motion detection can be
changed. Enter a desired rate in a range of fps 0.5 to 30.0.
(2)Enable preset selection
When this check box is selected, you can select the camera position using a preset.
3. Set the motion detection area ([Area] tab).
Up to four motion detection areas can be created, where the frame of each area can be
resized/moved by dragging. To resize the frame, drag "
" at four corners/on four sides. To
move the frame, drag a point inside the frame. You can also set a separate motion detection
level for each area. This camera lets you set the motion detection level while playing the video
recorded in the [Live] tab ( P. 2-43).
Note
The value set in [Maximum Frame Rate: Image Transmission] ( P. 1-22) must be greater than
the frame rate set by this tool.
Tip
z If the network load is heavy, the specified frame rate may not be achieved.
z By setting a lower frame rate, the video extracted from the captured video will be included
in the scope of motion detection. This way, you can also perform motion detection for slow-
moving subjects, etc.
z The frame rate set here is applied only to motion detection.
z Presets outside the view restriction are not shown in the preset list.
(1)
(2)