Canon MV500i Camcorder User Manual


 
75
E
Using the Full
Range of Features
Returning to a Pre-Marked Position
Use the wireless controller to mark a point on a tape that you want to return to
following playback.
1. Press the ZERO SET MEMORY button on the wireless controller
during playback at a point you want to return to later.
The time code is replaced by a tape counter that is set to zero with the
Â
indication.
Press the ZERO SET MEMORY button once more to cancel the zero set
memory.
2. When you have finished playback, fast forward or rewind the tape.
The tape stops automatically when it reaches the zero set position.
RTN1 or `RTN appears in the display.
The tape counter with
Â
indication disappears from the display and the time
code reappears.
Notes:
The zero set memory may not function correctly where there is a break between
recordings on the tape.
You can also use zero set memory to mark a position on a tape in CAMERA
mode. When you then play back the tape, pressing rewind will take you back to
the pre-marked position.
If you remove the tape while the zero set memory is set, the memory is
cancelled and the tape counter reverts to time code.
The camcorder remembers your setting even if you turn it off and back on again
or move the program selector.
REW
PLAY
FF
SEARCH
SELECT
STOP
PAUSE
SLOW
×2
+ / /
POWER
CAMERACAMERA
PLAY(VCR)
OFF
AUDIO
DUB.
ZERO SET
MEMORY
,
PLAY
(VCR)
CAMERA
#3_ MV500/MV500i__E(38-75) 2/6/02 14:17 Page 75