Filter
Top Products
88
E
Editing
Audio Dubbing
Notes:
• When you add sound using the built-in microphone make sure not to connect
any cables to the MIC terminal.
• To use your TV to monitor video, connect the S-video terminal ( 34) or the
AV terminal (use only the video plug) to your TV. You can monitor the sound
with headphones only when using the S-video terminal ( 32).
- For MV500 (For MV500i, 90).
You can add sound to the original sound on a pre-recorded tape recorded in the
SP mode with 12-bit sound. Use the internal or an external microphone. The
original sound will not be erased.
For best results, add sound to tapes that have been recorded with this camcorder
in SP mode with 12-bit sound. If there are non-recorded portions on the tape, or
portions recorded in a mode other than SP mode, or with 16-bit or 12-bit, 4-
channel sound, dubbing will stop. You cannot dub audio onto a tape recorded with
12-bit and 16-bit sound intermingled.
To connect an external microphone:
Preparations
Turn the camcorder’s POWER switch to PLAY (VCR) and load a recorded
cassette.
• Make sure the REC/SAVE tab on the cassette has been slid to REC (closed
position).
#4_ MV500/MV500i__E(76-95) 2/6/02 14:18 Page 88