Filter
Top Products
57
This is a connection mode available when using an access point
compatible with Wi-Fi Protected Setup (WPS). In pushbutton
connection mode (PBC mode), the camera and the access point can be
connected simply by pressing the WPS button for the access point.
Note that if multiple access points are active in the surrounding area, it
may be more difficult to establish a connection. In this case, try using
[WPS (PIN mode)] to establish a connection.
Check the position of the WPS button at the access point in advance.
It may take about one minute to establish a connection.
If stealth functions of the access point are enabled, connection
may be disabled. Deactivate stealth functions.
1
Select [Wi-Fi function].
Under the [53] tab, set [Wi-Fi] to
[Enable], then select [Wi-Fi
function].
2
Select an item.
Select either [q], [D], [l], or [ ],
then press <0>.
Easy Connection via WPS (PBC Mode)
COPY