Filter
Top Products
18
Loading and Unloading Film
2
Open the back cover.
•
Slide the back cover release lever as
shown by the arrow.
1
Turn the Command Dial to any
setting except < >.
3
Insert the film cartridge at an
angle as shown in the illustration.
4
Align the edge of the film with the
orange
<>
index mark.
•
Hold down the film cartridge while
pulling out the film leader.
•
If the edge of the film leader goes
beyond the orange mark, rewind some
of the film back into the cartridge.
Right
Wrong
Loading Film
5
Close the back cover.
•
Check that the edge of the film is
aligned with the < > mark, then close
the back cover until it snaps shut.
After you close the back cover, the
film will start winding on the take-up
spool and the frame counter will
count up.The camera will then make
a shutter-release sound and the
< > icon and total frame count will
be displayed.
During the film’s prewind, the ISO
speed is displayed on the LCD panel.
After you load the film, the camera first winds the entire roll onto the
camera’s take-up spool. With DX-coded film, the camera automatically
sets the film’s ISO speed.Then each time a picture is taken, one frame
of film is rewound back into the film cartridge.The frame counter shows
always number of shots remaining.
NNN E SEC1 (13-20) 02.5.11 10:46 AM Page 18