Filter
Top Products
Manual Flash Mode
Firi'ngBothFlashTtllbe~
$t aD,ifferentOutput
I
• The flash output is displayed
on
the
lower right of the LCD panel. When
A is displayed, the flash output
displayed is for flash tube
A.
Press the < <J >
or
<
C>
>
button
to
select flash
tube
A
or
B,
then
press the < +>
or
<- >
button
to
set
the flash output.
~
First select
the
flash
tube,
then
set
the
flash
output for that
flash
tube.
• The remaining steps are the same as
steps 6 and 7 on the preceding page.
M
M
IiJ.iDI!) A : B
~tD
For step 3 on the preceding page, following the procedure below to set a
different flash output between flash tube A and B
Press the <RATIO>
button
and
select
IiBml
A : B •
~
Each
time
you
press
the
button,
the
selection
will
change
in
the
following
loop:
r--+(OFF)-~
IiBml
A : BI
~IiBmlA:B:C~
Firing Only One Flash Tube
Press the
<->
button and set the flash output to --. This disables the
selected flash tube from firing.
• The -- setting comes after the 1/64 setting. The flash tube whose flash
output is set to -- will not fire. Also, you cannot set -- for both flash tubes.
39