Filter
Top Products
Troubleshooting Guide
II
The MR-14EX's mounting foot
is
not securely mounted
on
the camera's
hot shoe.
~
Slide the mounting foot all the way into the hot
shoe.(~p.13)
The camera's hot shoe contacts or the MR-14EX's contacts are soiled.
~
Clean the contacts.
(~p.13)
Batteries have not been installed
in
the MR-14EX.
~
Install batteries
in
the MR-14EX.
(~p.10)
The batteries
in
the MR-14EX are exhausted.
~
Install new batteriesin the MR-14EX.
(~p.1
0)
Flash exposure compensation has been set.
~
Cancel the flash exposure compensation.
(~p.32,
56)
C.Fn-5-1 has been set.
,
~Set
C.Fn-5-0.
(~p.64)
IiBiI!l A : B C (1iBiI!l A : B : C ) has been set
~
Set to IiBmJ
A:
B.
(~27,
39, 61)
The main switch is set to SE.
~
Set the main switch to ON.
(~p.15)
~
Press the test firing button.
(~p.16)
The locking collar has not been loosened enough.
• Loosen the locking collar until the locking pin
disengages.(~p.13)
"C.Fn-3-1 has been set.
~
Set C.Fn-3-0.
(~p.64)
The slave unit's wireless selector is set to OFF or MASTER.
~
Set the wireless selector to SLAVE.
(~p.16
of 550EX
Instructions/~p.13
of 420EX Instructions)
The
slave unit is not within the master unit's wireless transmission range.
~
Position
the
slave
unit
within
the
master
unit's
wireless
transmission
range.
(-7p.43,
63)
The slave unit's transmission sensor is not facing toward the master unit.
~
Face the slave unit's transmission sensor toward the master
~nit.
(~p.43,
63)
Slave C is pointed directly
'at
the front of the subject.
~
Use slave C in another way.
(~p.43)
68