Filter
Top Products
Manual Flash Mode
• The flash output is displayed on the
lower right of the LCD panel. When
A is displayed, the flash output
displayed is for flash tube
A.
Press the <
<J
> or <
C>
> button to
select flash tube A or
B,
then
press the
< + > or < - > button to
set the flash output.
~
First select the
flash
tube,
then
set
the
flash
output for that
flash
tube.
• The remaining steps are the same as
steps 6 and 7 on the preceding page.
M
M
fiBiI!)
A : B
~.D
After step 3 on the preceding page, following the steps below to set a
different flash output between flash tube A and
B.
Press the <RATIO> button and
select
IimiI!l A: B •
~
Each
time
you
press
the
button,
the
selection
will
change
in
the
following
loop:
~(OFF)-~1imiI!l
A: B I
~IimiI!lA:B:C~
Press the
<->
button and set the flash output to --. This disables the
selected flash tube from firing.
• The -- setting comes after the 1/64 setting. The flash tube whose flash
output is set to -- will not fire. Also, you cannot set -- for both flash tubes.
61