Filter
Top Products
11
IMPORTANT:
A hardware reset of the Internet Camera is now required to allow the IP Installer
program to configure the camera correctly. To accomplish this reset, lightly insert
a paper clip (or a similar sized tool) into the reset hole on the back of the camera
(see page 6 for the location of the reset hole.) The LED on the front of the
camera will begin blinking red and green. When it stops the blinking cycle continue
to hold in the reset button until a second cycle of blinking red and green lights
indicates a second reset cycle has completed. This will take approximately 5-7
seconds.
The IP Installer will now show a MAC address for the DCS-5300 and an IP
address. This IP address may not be correct at this step in the installation.
Software Installation (continued)
The opening IP Installer screen will
appear and show a MAC address
of the DCS-5300 and an IP Address
(which may or may not be correct
depending on what you have your
DCS-5300 connected to.) If you
have a DHCP* server on your
network, there will be a valid IP
Address displayed here.
*A DHCP server is a device that
supplies IP Addresses to its clients
that are on the same network.
Click on the Link button
Highlight the MAC address
146
146