Filter
Top Products
33
Configuration > Advanced > Network
Reset IP Address at next boot
Using the DCS-5300 with an Internet browser
(continued)
Once the DCS-5300 is configured, this box should be unchecked at all times. If
the box has been checked and the connection is lost, either run IP Installer or
PING the IP Address of the camera from a command prompt to regain the
connection.
IP address - Necessary for network identification.
Subnet mask - Used to determine if the destination is in the same
subnet. The default value is “255.255.255.0.”
Default router - The router used to forward frames to destinations
in a different subnet. Invalid router settings may
cause the failure of transmissions to a different
subnet.
Primary DNS - Primary domain name server that translates
names to IP addresses.
Secondary DNS - Secondary domain name server to backup the
primary one.
General Settings
Can be set to other than the default port 80. When
the administrator changes the HTTP port of the
DCS-5300 (which has an IP address of
192.168.0.146) from 80 to 8080, users must type
http://192.168.0.100:8080 in the Web browser
bar.
HTTP Port-
HTTP Settings