Edimax Technology NVR-4 Security Camera User Manual


 
84
CHAPTER IV: APPENDIX
4.1 Troubleshooting
Please don’t panic when you found this NVR is not working properly. Before you send this
NVR back to us, you can do some simple checks to save your time:
Problem Solution
Cannot connect to the NVR
1. Please check the IP address of NVR again.
2. Please make sure the network cable is correctly
connected to your local area network.
3. Please make sure power cable is correctly connected
to NVR.
4. Please make sure NVR is switched on (the LED lights
on front panel or NVR will light up).
No network camera found 1. ‘Auto search’ function only works on IP cameras
located on local area network. To add a remote IP
camera, you must use manual configuration.
2. Only ‘EDIMAX’ IP cameras are supported currently.
4.2 Specifications
Description 4 CH Network Video Recorder
Microprocessor Cavium
Flash ROM 32 MB
RAM 256 MB
Supported Image Format H.264 / MPEG-4 / M-JPEG
Maximum Number of Cameras 4 Channels
HDD Type SATA I/II/III Compatible
HDD Bay & Max. Capacity 2 Bays ; Total capacity: 2TB x2 ( SATA 3.0 )
RAID Standard, RAID 0, 1(Mirror)
Network Interface 10/100/1000 Mbps RJ45 Ethernet port
USB USB 2.0 x 1: supporting Flash-disk
Buttons Reset / Power on/off
LEDs Power / Network Indicator / HDD Status Indicator /
USB Indicator
Recording Mode Continuous / Manual / Schedule /Motion Detection
Alarm Yes
Event Yes
Snapshot Yes