Filter
Top Products
Setting Up the Document Camera
13
Connecting to a Computer
The document camera comes with one RGB video input port. This
can be used to connect a laptop or desktop computer to the document
camera.
This is especially useful if your projector has only one input port. You
can connect a computer to the document camera’s RGB input port as
described below, and connect the document camera to the projector’s
input port as described on page 11. This way, you can use the
camera’s remote control to switch between picture sources. Follow the
instructions on page 20 to switch between the sources.
Before you start, make sure your document camera and computer are
turned off.
1. Connect one end of the RGB video cable to the document
camera’s
RGB IN
port.
2. Connect the other end of the RGB video cable to your computer’s
RGB video output (monitor) port.
3. Tighten the screws on the connectors.
AC IN
RGB IN
RGB OUT
ON
OFF
RS-232C
POWER
VIDEO
OUT
USB
0
1
A
B
C
computer
or
laptop
elpdc04.book Page 13 Tuesday, February 12, 2002 8:32 AM