Filter
Top Products
Loading Paper 15
7. Slide the edge guide to the side of the media, but not too tightly.
Note:
If the printer doesn’t load the media and the I paper light flashes when printing
starts, gently pull out the media and turn off the printer. Then turn on the printer
and try again.
Caution:
Don’t turn off the printer when thick media is loaded or you may damage the
printer. To remove the media from the printer without printing, gently pull out the
media.
8. When you’re finished printing on thick media, close the front manual feed
slot cover.
spr2880_ug.book Page 15 Monday, April 6, 2009 1:10 PM