Filter
Top Products
16
Monitor Name : _ _ _ _
Video Connected to
DVR : _ _ _ _ Matrix : _ _
Monitor : 0001 changed
[ ENT ] to save
Video Connected to
DVR : _ _ _ _ CH : _ _
Setup of the RS-485 interface used for telemetry
cameras, port 1 or 2.
Enter any value for fixed cameras (numeric entry compulsory).
Press Enter to confirm the setting and Esc to cancel.
Setup of DVR and video input to which the camera is connected
(requires a DVR installation in the “DVR Setting” menu)
Enter any value if no DVR is connected
(numeric entry compulsory).
Press Enter to confirm the setting and Esc to cancel.
8.3.2. Call and matrix monitor setting
Define the DVR call and matrix monitors to be controlled by the keyboard. These settings are irrelevant
for main monitor camera management.
Call and matrix monitors can only be managed by EKB 500 after definition in this menu. By this, an
administration of system access rights can be set up, as only monitors defined in this menu are available
for access.
MENU > DEVICE SETTING > MONITOR SETTING > Enter
Monitor number, entry 1 ~ 9999 (independent
of DVR monitor number).
Press Enter to confirm the setting and Esc to cancel.
The following menu item allows the matrix monitor assignment
to the respective DVR’s call / monitor output.
ATTENTION: EDR / EDSR series’ monitor numbering:
DVR > EKB-500 input
CALL > Matrix: 1
Matrix 1 > Matrix: 2
Matrix 2 > Matrix: 3
Matrix 3 > Matrix: 4
Matrix 4 > Matrix: 6
Press Enter to confirm the setting and Esc to cancel.
RS485 Connected to
Port : _ [ 1 or 2 ]