Filter
Top Products
33
Speed:___[1-239]
[ENT] to start.
9.2.3.2. Presets
Save presets
Shift (hold) + POSITION
> enter preset number > Enter
Delete preset
Clr (hold) + POSITION
> enter preset number > Enter
Start preset
POSITION > enter preset number > Enter
9.2.3.3. Autopan
End stop definition
Define both the end stops and the autopan speed in the speed dome’s on-screen display. For further
details, please refer to the manual of the respective model.
Start A-B Autopan
A.Pan > enter pan speed 1~ 239
(any input, value is irrelevant due to speed being defined
in the dome menu)
> Enter
ATTENTION: At some third party domes with implemented Pelco-D the Autopan starts with alternative
command:
POSITION > 99 > Enter
9.2.3.4. Frame Scan / Preset tour
Frame scan is a modified Autopan mode, the Autopan stops at defined positions for a programmed time.
Settings for this are defined in the speed dome OSD manual. At some third party domes with
implemented Pelco-D protocol this command starts Preset tour.
Start Framescan
POSITION > 98 > Enter
Camera:0001 go to
Position:___[1-192]
Camera:0001 Save to
Position:___[1-192]
Camera:0001
Del Position:___