Filter
Top Products
32
Speed:___[1-239]
[ENT] to start.
9.2.2.4. Autopan
End stop definition
Define both the end stops and the autopan speed in the speed dome’s on-screen display. For further
details, please refer to the manual of the respective model.
Start A-B autopan
A.Pan > enter pan speed 1~ 239
(any input, value is irrelevant due to speed being defined
in the dome menu)
> Enter
9.2.2.5. Preset tour / Pattern
Define patterns (stored motion sequences of 30 seconds each) in the speed dome’s on-screen display.
For further details, please refer to the manual of the respective model.
Activate pattern
Tour
> enter pattern number 1~3 > Enter
Activate Preset Tour
Tour
> 0 > Enter
9.2.3. Pelco-D / -P protocol compatible devices’ operation
Required protocol type in "COM PORT SETTINGS": Pelco-D / Pelco-P (according to dome / receiver)
Implemented protocol is based and tested with Spectra III
TM
series halfduplex RS-485.
Third party domes with implemented Pelco-D protocol may have different features and
ATTENTION: Some Pelco-D / -P protocol domes and receivers require an address offset of -1 at the
keyboard, i.e. the address assigned to the dome / receiver in the EKB 500 menu must be 1 below the
address set in the dome / receiver itself!
9.2.3.1. On-screen display
Start menu: MENU
or Preset > 9 5 > Enter
Switch between the settings: Shift (hold) + JOYSTICK
Change the settings: IRIS +
Leave the menu: EXIT entry in OSD menu, confirm with IRIS +
alternative: MENU
or Preset > 9 5 > Enter
For exit of some sub-menus the key IRIS - is used.
Camera:0001
Run Tour:__[1-16]