Filter
Top Products
FREE RUN Mode - When the user
enables FREE RUN mode, DR-DV5000
begins counting from the value stored. If the
user uses the TC PRESET function, when the
number is entered and the TC PRESET menu
is exited, DR-DV5000 begins counting.
NOTE: When the DR-DV5000 timecode
mode is set to EXT TC and the camcorder
time code mode is set to PRST/REC or
REGEN, it is not possible to record timecode
continuously when recording to disk only. Set
the DR-DV5000 timecode mode to REGEN,
REC RUN or FREE RUN(not EXT TC) when
recording to disk only.
Timecode, UserBit and Drop/Non-Drop
Preset
This menu allows the user to set timecode
and user bit values for various modes. It
also allows selection of drop or non-drop
frame (NTSC only) settings. User simply
selects the Menu Item. Pressing SEL will
open the sub menu. Pressing EXIT will exit
back to the menu screen.
Once a timecode value is set and DR-DV5000
is set to REC RUN or FREE RUN timecode
settings, the preset value will be the starting
point for timecode. Use the forward and back
index buttons to move from value selection to
value selection. Press the up and down arrows
to set values.
Allows the user to set a user bit value. Use the
forward and back index buttons to move from
value selection to value selection. Press the up
and down arrows to set values.
For DROP and NON-DROP, user simply
selects the mode. Highlighted mode is current
mode after exit. Pressing EXIT will exit back
to the menu screen. This item not applicable
for PAL use. On the DR-DV5000 display,
DROP will be identified by a (.) symbol and
NON-DROP by a (:) symbol.
Infrared Sensor Settings
FireStore DR-DV5000 User Guide
PAGE 29