Filter
Top Products
FS-2/2E Studio DTE Disk Recorder User Guide
13
Introduction
To set up the FS-2/2E, do the following:
1. Plug in the power cord.
2. Connect a Video input device.
3. Connect an Audio source (if desired).
4. Connect a Monitor if desired.
5. Connect Speakers or Headset (to monitor the audio) if desired.
6. Connect a Tape Drive if desired.
7. Connect a Time Code Generator if desired.
8. Connect an External Control Device (RS422) if desired.
9. Connect a Reference Video signal if desired.
1.9.1 Formatting the Drive
Use this procedure to format the FS-2/2E internal or connected external
disk drives when not yet formatted.
1. From the Utilities menu, select FORMAT DISK as shown below.
When you make this selection, the following screen appears:
2. Select between volumes by pressing the | and | buttons.
• When you select the volume and press YES, the following screen
appears:
• When you select YES, a message indicating that the formatting is
progressing appears.
3. Press EXIT to return to the menu screen.
WARNING: FORMAT ERASES ALL DATA ON THE DISK
DRIVE!
FORMAT DISK
VOLUME 1?
SIZE 115 Gig
FREE 540 Min
EXIT YES NO
FORMAT WILL
ERASE ALL DATA!!
CONTINUE
FORMAT VOL 1?
EXIT YES NO