Filter
Top Products
FS-2/2E Studio DTE Disk Recorder User Guide
75
FS-2/2E Functions
2. Connect a host computer to the TO COMPUTER
port on the back of the FS-2E next to the EtherNet
port.
2.5.12.21 GENLOCK
The GENLOCK menu allows you to select and adjust the reference
video source and whether the video out will be locked to the
reference video input in playback modes.
•
SOURCE - Selects the source of the sync pulses used to time
the output video during playback. Choices are:
•REF VIDEO - the reference video port on FS-2/2E's rear
panel,
• FREE RUN - reference video is generated internally on
the FS-2/2E. When this option is selected the menu is
simplified and only the above selections are in the
GENLOCK menu.
•
SC PHASE - Allows the subcarrier phase to be adjusted
between +127 and -128. The default value is set at 0.
Press and hold either
or for more than 3 seconds to
change the value by increments of ten.
•
H PHASE - Allows the horizontal phase to be adjusted
between +127 and -128. The default value is set at 0.
Press and hold either
or for more than 3 seconds to
change the value by increments of ten.
Loop-Through or Terminated Output
If the loop-through jack is not connected, make sure the output is
terminated using an external 75 ohm terminator.
FS-2E Backpanel
Ethernet
10/100 Base T
To Computer