Filter
Top Products
FS-2/2E Studio DTE Disk Recorder User Guide
viii
Electrical Precautions
Do Not Expose to Moisture
Do not use this product near water or in an environment where it is
exposed to dampness or there is the possibility of it getting wet.
Do Not Remove Cover
There are
No User Serviceable Parts inside this unit. Servicing should be done
by qualified service personnel.
ON / OFF Switch in Stand-By Position
The On/Off switch Does Not Separate the Unit From the Main Power when it is
in the stand-by position.
Power Sources
Use only power sources that match those indicated on the marking label. If
unsure of the type of power supply that is available, consult your dealer or
local power company.
Do Not Overload Power Outlets
Do not overload wall outlets, extension cords, or integral convenience
receptacles as this can result in a risk of fire or electric shock.
Verify Power Plugs are Fully Inserted
To prevent potential electrical shock to personnel, verify that the FS-2/2E
power cord plug is fully inserted into a grounded receptor and that the
plug blades are not exposed.
ATTENTION
POUR PREVENIR LES CHOCS ELECTRIQUES NE PAS UTILISER CETTE
FICHE POLARISEE AVEC UN PROLONGATEUR, UNE PRISE DE
COURANT OU UNE AUTRE SORTIE DE COURANT, SAUF SI LES
LAMES PEUVENT ETRE INSEREES A FOND SANS EN LAISSER
AUCUNE PARTIE A DECOUVERT.
Power-Cord Protection
• Routing Power-Cords
Route power supply cords so that they are not likely to be walked on
or pinched by items placed upon or against them. Avoid sharp angles
in the cord, particularly at plugs, convenience receptacles, and the
point where they exit the product.
•
Non-Use Period
During extended periods when the device is not used, unplug it from
the power source and retract the power-cord.