Filter
Top Products
90 91
6
91
ADJUSTING THE LCD MONITOR BRIGHTNESS AND THE SPEAKER VOLUME
90
You can check the file number by viewing the
image. The last 4 digits of the 7-digit number in
the top right corner of the screen are the file
numbers, while the first 3 digits show the
directory number.
Setting this function to “CONT” makes file
management easier as it ensures that file names
are not duplicated when images are downloaded
to a PC.
RENEW: Pictures are stored on each SmartMedia
beginning with a file number “0001”.
CONT : Pictures are stored beginning from the
highest file number stored on the last
SmartMedia used.
●
!
If the SmartMedia already contains image files with
file numbers higher than the highest file number on
the last SmartMedia, images are stored beginning
from the highest file number on the current
SmartMedia.
●
!
When you change the SmartMedia, always switch the
camera off before you open the battery cover. If you
open the battery cover without switching the camera
off, the frame number memory will not function.
●
!
File numbers run from 0001 to 9999. Once 9999 is
exceeded, the directory number goes up by 1. The
maximum number is 999-9999.
●
!
If you switch the Frame No. Memory function off, the
highest file number stored by the function is reset.
●
!
The displayed frame number may differ for images
photographed on other cameras.
AA
BB
File number
Directory number
Frame number
✽ Formatted SmartMedia used for both A and B.
FRAME NO. MEMORY
2
1
If you hold down the “DISP” button for 2 seconds,
the “Adjustment bar” appears.
●
Adjusting the BRIGHTNESS
You can only adjust the brightness when the
Mode dial is set to either “
0
” or “
1
”.
●
Adjusting the VOLUME
The speaker volume can only be adjusted
when the Mode dial is set to “
1
” and a movie
file is selected.
➀
Press “d” and “c” button to adjust the LCD
monitor brightness or the speaker volume.
Use “a()” and “b()” button to switch
between brightness and volume.
➁
Press the “MENU/OK” button to confirm the
setting.
●
!
If movie playback is in progress, playback is paused.
●
!
The settings cannot be changed if the LCD monitor
is switched off.
●
!
To exit this procedure without changing the settings,
press the “BACK” button.
●
➀
●
➁