Filter
Top Products
65
Viewing Images
64
Windows XP
1
The “Found New Hardware” help message
appears in the bottom-right corner of your
screen. This message will close when the
settings are completed. No action is required.
●
!
This step is not required for subsequent connections.
Proceed to “Using FinePixViewer” on page 67.
◆
Regarding the Icons
◆
The next time you connect the camera, the removable disk drive icon and name change to the
“FinePix” icon and name.
2
Specify the settings in the “AutoPlay” dialog box.
h When FinePixViewer is included in the list of actions to perform
Select “Viewing images using FinePixViewer” and then select the “Always do the
selected action” checkbox. (This checkbox may not be shown in some cases.)
Click the [OK] button to launch FinePixViewer.
h When FinePixViewer is not included in the list of actions to perform
Select “Take no action” and then select the “Always do the selected action” checkbox.
(This checkbox may not be shown in some cases.)
Click the [OK] button and launch FinePixViewer manually.
3
A new removable disk icon appears in the “My Computer” window.
CAMERA CONNECTION
If you are using a Windows PC, the driver settings are specified automatically when installation is
completed. No further action is required.
Always use the prescribed procedure when disconnecting or switching off the camera (➡P.66).
●
!
On Windows XP and Mac OS X, you must specify the automatic launch settings the first time you connect the
camera to your computer.
●
!
Take care to ensure that the included USB cable is connected the correct way around and that the plugs are pushed
fully into the connection sockets.
h When the camera and computer are exchanging
data, the self-timer lamp blinks and the viewfinder
lamp blinks alternately green and orange.
h ““” appears on the screen.
h Power Save and Auto Power Off are disabled
during USB connection.
●
!
Before replacing the xD-Picture Card, always disconnect the
camera from the PC using the procedure on P.66.
●
!
Do not disconnect the USB cable when the camera is
communicating with the PC. See P.66 for information on the
disconnection procedure.
●
!
The Windows CD-ROM may also be required during installation. In this event, switch CD-ROMs as directed by the
on-screen instructions.
h FinePixViewer automatically starts up.
✽ Screen for Windows 98 SE
Camera Operation
PC Operation
Windows 98/98 SE/Me/2000 Professional
h A removable disk icon appears and you can use your PC to transfer files to and from the
camera.
Windows Macintosh
If the above operations do not occur, you do not have the required software programs or drivers
installed on your PC. Complete the required PC setup procedures. Then reconnect the camera to
your PC.