Filter
Top Products
f Description
- Upon receiving the detected paper information from the read command
(Data type code = Xπ81π), the driver or application software must specify
the window area (Set window command Byte 6 to 15) and the paper size
(Set window command Vender unique parameter byte 35) using the set
window command.
- The detected paper information is accessed with the read command (Data
type code = Xπ81π).
- Once paper is fed by issuing the object position (Unload object) command,
the direction to which paper is loaded (paper direction) is accessed with the
read command (Data type code = Xπ81π).
f Job separation sheet Byte 2
Xπ80π: Job separation sheet is detected.
Xπ00π: Job separation sheet is not detected.
f Paper size
Byte 3
Reserved
Format of detected paper information
Reserved
Job separation sheet
Paper size
Reserved
Byte 0
Byte 1
Byte 2
Byte 3
Byte 4
Byte 5
Byte 6
Byte 7
b7 b6 b5 b4 b3 b2 b1 b0
Following paper size is detected.
0000: Undefined 1000: Undefined
0001: Undefined 1001: Undefined
0010: Undefined 1010: Undefined
0011: A3 or DL 1011: Undefined
0100: A4 or LT 1100: B4
0101: A5 1101: B5
0110: Undefined 1110: Undefined
0111: Undefined 1111: Undefined
0: Portrait 1: Landscape
0: Paper size detected, when the paper is fed from ADF.
1: Paper size not detected, when the paper is fed from ADF.
0: The Paper is loaded into ADF (Except 1st page).
1: The paper is ejected from ADF.
Note:
Bits 4, 5, and 6 are effective only when image data has been read. An ™*1∫ in
Figure 1.1.1 shows the effective timing.
D $ 4