Fujitsu M4000 Security Camera User Manual


 
setcod(8)
System Administration 125
NAME setcod - set up the Capacity on Demand (COD) resources used for domains
SYNOPSIS setcod
setcod [-v] headroom
setcod [-v] -d domain_id [ proc-rtus]
setcod -h
DESCRIPTION setcod(8) sets up the COD resources to be used for domains. License keys must be
installed (see addcodlicense(8)) before COD boards in a domain can be utilized.
You can also enable headroom and reserve licenses for some domains with
setcod(8).
When no domain_id is specified, current values are displayed in the square brackets
([]) at the command prompt. If no value is specified for an operand, it retains its
current value.
Privileges You must have platadm privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
OPERANDS The following operands are supported:
EXTENDED
DESCRIPTION
If you run the setcod command without specifying any options, the command
prompts you for COD information.
You are asked to specify the amount of COD headroom to be used, and the number
of COD RTU licenses to be reserved for your domains. When you are prompted for
-d domain_id Domain identifier. domain_id can be 0–23 depending on
the system configuration.
-h Displays usage statement.
When used with other options or operands, an error
occurs.
-v Specifies verbose output.
headroom Amount of headroom (processors) to be
enabled. Maximum value is 4.
proc-rtus The number of Right To Use (RTUs)
licenses reserved for a domain. One RTU
license is required for each CPU.