Filter
Top Products
setdscp(8)
144 XSCF Reference Manual • Last Revised January 2007
Note – The -y and -n options can be used (with or without the -q option) when
running setdscp in interactive mode.
Privileges You must have platadm or fieldeng privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
EXAMPLES
Caution – The IP addresses shown in the following examples are examples only.
Refer to the site planning guide for your server for information about valid IP
addresses for your network. Using invalid network IP addresses could, under
certain circumstances, make your system unbootable!
-d domain_id Domain identifier. Must be used with -i address option. domain_id
can be 0–23 depending on the system configuration.
-f Forces setdscp to ignore out of range and address conflict errors
and commits the new settings.
-h Displays usage statement.
When used with other options or operands, an error occurs.
-i address Specifies an IP address in the IPv4 dotted decimal format.
When used with -m netmask it specifies a network address for
all DSCP links in the system.
When used with -d domain_id it specifies an individual,
domain-specific IP address for use by DSCP.
When used with -s, it specifies the IP address used for the
Service Processor end of all DSCP links in the system.
-m netmask Specifies a netmask address for all DSCP links in the system. Must
be used with -i address.
-n Automatically answers n (no) to all prompts.
-q Suppresses all messages to stdout, including prompts.
-s Must be used with the -i address option. Specifies the Service
Processor end of all DSCP links in the system.
-v Displays a detailed message. If this option is specified with the -q
option, the -v option is ignored.
-y Automatically answers y (yes) to all prompts.