Fujitsu M4000 Security Camera User Manual


 
showntp(8)
System Administration 333
NAME showntp - display the NTP servers currently set for the XSCF network
SYNOPSIS showntp {-l | -a | address}
showntp -h
DESCRIPTION The showntp(8) command displays the NTP servers currently set for the XSCF
network.
Besides being capable of displaying the NTP servers that are set, the command can
be used to confirm the following information:
Whether synchronization with an NTP server is being maintained
Whether the NTP service has been started
Privileges You must have one of the following privileges to run this command:
useradm, platadm, platop, auditadm, auditop, domainadm, domainmgr,
domainop, fieldeng
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
OPERANDS The following operand is supported:
EXTENDED
DESCRIPTION
The setntp(8) command sets the NTP servers used in the XSCF network.
-a Displays all the NTP servers currently set for the XSCF network.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-l Displays whether synchronization with an NTP server is being
maintained.
address Specifies the IP address of an NTP server to be displayed. A
specified IP address is a set of four integer values delimited by
the period (.). If the -a option is specified, the operand is
ignored. The following address form is accepted:
xxx.xxx.xxx.xxx
where:
xxx An integer from 0–255. Zero suppression can
be used to specify the integer.