Filter
Top Products
setnetwork(8)
172 XSCF Reference Manual • Last Revised January 2007
OPERANDS The following operands are supported:
EXTENDED
DESCRIPTION
■ If one network interface is disabled when the applynetwork(8) command is
executed, all network interfaces are deleted. To enable that network interface
again, configure all network interfaces again.
■ In a duplicated configuration, a takeover IP address can be used without a need
to determine whether XSCF has been switched. By setting the LAN ports of the
active XSCF unit as lan#0 and lan#1, they can be accessed with the names
lan#0 and lan#1. As default values, lan#0 is set to xscf#0-lan#0 and lan#1 is
set to xscf#0-lan#1.
■ When the XSCF unit is not duplicated configuration, the value of the lan#0 is
fixed with xscf#0-lan#0, and the lan#1 is fixed with xscf#0-lan#1.
■ The shownetwork(8) command can display current information on a network
interface configured for XSCF.
interface Specifies the network interface to be configured. One of the
following values can be specified:
For XSCF unit 0 :
xscf#0-lan#0 XSCF-LAN#0
xscf#0-lan#1 XSCF-LAN#1
xscf#0-if Interface between XSCF units (Inter SCF
Network; ISN)
For XSCF unit 1 (when a duplicated configuration is used):
xscf#1-lan#0 XSCF-LAN#0
xscf#1-lan#1 XSCF-LAN#1
xscf#1-if ISN
For takeover IP address:
lan#0 takeover IP address for XSCF-LAN#0
lan#1 takeover IP address for XSCF-LAN#1
address Specifies an IP address. The specified value is a set of four
integer values delimited by the period (.). The following address
form is accepted:
xxx.xxx.xxx.xxx
xxx An integer from 0–255. Zero suppression can
be used to specify the integer.