Filter
Top Products
setlocator(8)
System Administration 165
NAME setlocator - control the blinking of the CHECK LED on the operator panel
SYNOPSIS setlocator value
setlocator -h
DESCRIPTION setlocator(8) command controls the blink state of the CHECK LED on the
operator panel.
The following states can be set:
Privileges You must have platadm or fieldeng privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following option is supported:
OPERANDS The following operand is supported:
EXTENDED
DESCRIPTION
The showlocator(8) command can be used to check the CHECK LED state.
EXAMPLES
EXAMPLE 1 Starts the CHECK LED blinking.
EXAMPLE 2 Stops the CHECK LED blinking.
Start blinking Makes the CHECK LED blink.
Stop blinking Stops the blinking of the CHECK LED.
-h Displays usage statement. When used with other options or
operands, an error occurs.
value Specifies the CHECK LED state. One of the following can be
specified:
blink Starts the CHECK LED blinking.
reset Stops the CHECK LED blinking.
XSCF> setled blink
XSCF> setled reset