Filter
Top Products
setupfru(8)
228 XSCF Reference Manual • Last Revised January 2007
OPERANDS The following operands are supported:
EXTENDED
DESCRIPTION
■ In a high-end server, the Quad-XSB configuration cannot be set in memory
mirror mode.
■ To set up an already mounted PSB again, all XSBs comprising the target PSB
must have been disconnected from the domain configuration and placed under
the system board pool. See the deleteboard(8) command for information on
how to disconnect XSBs from the domain configuration.
■ The configuration of the PSB varies according to the system as shown below.
■ In a high-end server, the PSB consists of one CPU memory board and one I/O
unit in combination.
■ In a midrange server, the PSB consists of one CPU module and one memory
module logically divided into two on the motherboard, and one I/O module.
■ The current PSB settings can be checked by using the showfru(8) command.
EXAMPLES
EXAMPLE 1 Configures PSB#00 as a Quad-XSB (with memory in non-mirror mode be-
cause the memory mirror mode setting is omitted).
EXIT STATUS The following exit values are returned:
SEE ALSO addboard(8), deleteboard(8), moveboard(8), setdcl(8), showboards(8),
showdcl(8), showdevices(8), showfru(8)
device Specifies the device to be set up. Only the following device can
be specified:
sb Physical system board (PSB)
location Specifies the location of the device.
sb Integer from 0–15. Specify only one location.
XSCF> setupfru -x 4 sb 0
0 Successful completion.
>0 An error occurred.