Fujitsu M5000 Security Camera User Manual


 
setnetwork(8)
172 XSCF Reference Manual Last Revised January 2007
OPERANDS The following operands are supported:
EXTENDED
DESCRIPTION
If one network interface is disabled when the applynetwork(8) command is
executed, all network interfaces are deleted. To enable that network interface
again, configure all network interfaces again.
In a duplicated configuration, a takeover IP address can be used without a need
to determine whether XSCF has been switched. By setting the LAN ports of the
active XSCF unit as lan#0 and lan#1, they can be accessed with the names
lan#0 and lan#1. As default values, lan#0 is set to xscf#0-lan#0 and lan#1 is
set to xscf#0-lan#1.
When the XSCF unit is not duplicated configuration, the value of the lan#0 is
fixed with xscf#0-lan#0, and the lan#1 is fixed with xscf#0-lan#1.
The shownetwork(8) command can display current information on a network
interface configured for XSCF.
interface Specifies the network interface to be configured. One of the
following values can be specified:
For XSCF unit 0 :
xscf#0-lan#0 XSCF-LAN#0
xscf#0-lan#1 XSCF-LAN#1
xscf#0-if Interface between XSCF units (Inter SCF
Network; ISN)
For XSCF unit 1 (when a duplicated configuration is used):
xscf#1-lan#0 XSCF-LAN#0
xscf#1-lan#1 XSCF-LAN#1
xscf#1-if ISN
For takeover IP address:
lan#0 takeover IP address for XSCF-LAN#0
lan#1 takeover IP address for XSCF-LAN#1
address Specifies an IP address. The specified value is a set of four
integer values delimited by the period (.). The following address
form is accepted:
xxx.xxx.xxx.xxx
xxx An integer from 0–255. Zero suppression can
be used to specify the integer.